Flow Control (conditional branching, looping) in Manual Inspection

If technically possible, it would be very powerful to allow some limited forms of "branching" and looping in a Manual Inspection.  

I am thinking of showing or hiding/skipping steps based on results in a previous step for example. 

Limited looping would also be a natural addition, for example to allow capturing "the same step n times" based on a numeric input in a previous step. 

I realize this would blur the line between what Manual Inspection was meant for, and developing more dedicated interfaces (.NET, TestStand, LabVIEW), but I believe there is a strong argument to be made to increase capability in Manual Inspections because the web-interface makes it so very portable!